http://www.Grannysspeedshop.com now has Nissan VG30 V-6 swaps available, engine mounts, transmission crossmember drive shaft, tach re cal and not sure what else i didnt really look into it. all i know is i wish it was for the 1st gen as well.

Can you throw in the TT? That would be fun

That'd be pretty baller and unique. I doubt it'd be too hard either. Marks engine looked tiny once it was all stripped down.

The kit is cheap too. The rough part is all the extra stuff. ANY swap will usually run you 3-4 grand without the engine...

Depends on what you do, mostly all of their kits are like 1,090.00
Before tax so like 1,200$ then an engine and random things you should fix while the engine is out.
Me i dont care what happens at this moment lol engine goes in eventually i think i may bring it to the mazda dealer and make them take the nut off. im pretty pissed off that theyd make such a stupid thing, but its all a money grabber, collin said like 47$ for the socket i need, then id also need to find a 3/4" or 1" breaker bar so lookin at about 100$ to take a flywheel nut off 15 mins of usage.

and they said somewhere in there plenty of room for a turbo... I donno about two but would be nice.

Just get the dam socket don't be so cheep! I would have plenty of use for it also..

Why dont you head to your nearest small town heavy duty shop and use their 3/4 or 1" impact with the proper socket for a case of beer. Fuck I could have that off for you in 2 shakes...............of my dick

True story ^

equicare in kimberley would have what you need.

+1 for Equicare. I used to work there, good guys!

i would suggest if you are going to do a v8 swap go with the cheapest easiest swap available for your car. do the ford 5.0 theres little to no customizing and if you get a carbed motor you dont have to worry about pesky wiring. they say on the site that all totalled you can do that swap for 1500 not including the motor.

i know dont have that kinda money just gonna get the fucking nut off then put back on and get it over with thats the only thing holding it back.

no offence but it kinda lame this is the only thing holding you back. take in some bottles and buy a socket . if you cant afford one socket in a 2 weeks span you should probably consider a huge life change or a bus pass

sorry if this sounds mean or arrogant im really just trying to say get on it

Remember travis, i work at a german resturant, we are taking about a 1981 RX7 is it really worth spending every penny of my paycheck on something im going to use once for 15 mins.

I'm not sure if you mean the socket or the car itself, could be either. As mentioned man, take it to a heavy duty shop, or whatever it takes, one nut shouldnt be such a huge hold up on a project, get er done!